Hugin Keyboard shortcuts

General shortcuts

The following keyboard shortcuts are available anywhere in hugin:

Ctrl-N, discard the current project and start a new empty project.
Ctrl-O, open an existing hugin, PTGUI, PTAssembler, autopano or autopano-sift project file.
Ctrl-S, save the current project as a hugin pto file.
Ctrl-Q, quit hugin.
Ctrl-Z, undoes the most recent change to the current project.
Ctrl-R, redoes an undo.
Ctrl-T, re-optimises the current project. This has exactly the same effect as clicking Optimize Now! in the hugin Optimizer tab.
Ctrl-P, shows the hugin Preview window.
Ctrl-A, selects all photos in the Hugin Images tab, Hugin Camera and Lens tab and Hugin Crop tab selects all points in the Hugin Control Points table.
Delete and Insert in the Hugin Images tab removes and adds photos to the project.
<F1>, opens the hugin manual.
<F3>, shows the hugin Control Points table.
<F11>, toggles Full Screen mode. Note that the Hugin Main window and the Hugin Fast Preview window can be maximised to full screen independently.
Shift-<F1>, Shift-<F2>,...Shift-<F9> switches between the tabs in the main window.
Ctrl-Tab, Ctrl-Shift-Tab, jumps from tab to tab to the right and to the left in the main window (if frontmost).

In addition to this there are a number of keyboard shortcuts available only in the hugin Control Points tab.