Hugin Keyboard shortcuts
From PanoTools.org Wiki
Revision as of 22:31, 30 January 2010 by Bruno (note F11 full screen mode)
The following keyboard shortcuts are available anywhere in hugin:
- Ctrl-N, discard the current project and start a new empty project.
- Ctrl-O, open an existing hugin, PTGUI, PTAssembler, autopano or autopano-sift project file.
- Ctrl-S, save the current project as a hugin pto file.
- Ctrl-Q, quit hugin.
- Ctrl-Z, undoes the most recent change to the current project.
- Ctrl-R, redoes an undo.
- Ctrl-T, re-optimises the current project. This has exactly the same effect as clicking Optimize Now! in the hugin Optimizer tab.
- Ctrl-P, shows the hugin Preview window.
- <F1>, opens the hugin manual.
- <F3>, shows the hugin Control Points table.
- <F11>, toggles Full Screen mode.
In addition to this there are a number of keyboard shortcuts available only in the hugin Control Points tab.