Difference between revisions of "Hugin Keyboard shortcuts"
Jump to navigation
Jump to search
(note F11 full screen mode) |
m (headlines) |
||
Line 1: | Line 1: | ||
+ | == General shortcuts == | ||
The following keyboard shortcuts are available anywhere in [[hugin]]: | The following keyboard shortcuts are available anywhere in [[hugin]]: | ||
Line 13: | Line 14: | ||
* '''<F11>''', toggles Full Screen mode. | * '''<F11>''', toggles Full Screen mode. | ||
+ | == Additional shortcuts == | ||
In addition to this there are a number of keyboard shortcuts available only in | In addition to this there are a number of keyboard shortcuts available only in | ||
− | the [[hugin Control Points tab]]. | + | the [[hugin Control Points tab#Keyboard_shortcuts|hugin Control Points tab]]. |
[[Category:Software:Hugin]] | [[Category:Software:Hugin]] |
Revision as of 12:39, 24 February 2011
General shortcuts
The following keyboard shortcuts are available anywhere in hugin:
- Ctrl-N, discard the current project and start a new empty project.
- Ctrl-O, open an existing hugin, PTGUI, PTAssembler, autopano or autopano-sift project file.
- Ctrl-S, save the current project as a hugin pto file.
- Ctrl-Q, quit hugin.
- Ctrl-Z, undoes the most recent change to the current project.
- Ctrl-R, redoes an undo.
- Ctrl-T, re-optimises the current project. This has exactly the same effect as clicking Optimize Now! in the hugin Optimizer tab.
- Ctrl-P, shows the hugin Preview window.
- <F1>, opens the hugin manual.
- <F3>, shows the hugin Control Points table.
- <F11>, toggles Full Screen mode.
Additional shortcuts
In addition to this there are a number of keyboard shortcuts available only in the hugin Control Points tab.