Hugin Keyboard shortcuts

From PanoTools.org Wiki
(Difference between revisions)
Jump to: navigation, search
(note F11 full screen mode)
m (headlines)
Line 1: Line 1:
 +
== General shortcuts ==
 
The following keyboard shortcuts are available anywhere in [[hugin]]:
 
The following keyboard shortcuts are available anywhere in [[hugin]]:
  
Line 13: Line 14:
 
* '''<F11>''', toggles Full Screen mode.
 
* '''<F11>''', toggles Full Screen mode.
  
 +
== Additional shortcuts ==
 
In addition to this there are a number of keyboard shortcuts available only in
 
In addition to this there are a number of keyboard shortcuts available only in
the [[hugin Control Points tab]].
+
the [[hugin Control Points tab#Keyboard_shortcuts|hugin Control Points tab]].
  
 
[[Category:Software:Hugin]]
 
[[Category:Software:Hugin]]

Revision as of 12:39, 24 February 2011

General shortcuts

The following keyboard shortcuts are available anywhere in hugin:

  • Ctrl-N, discard the current project and start a new empty project.
  • Ctrl-O, open an existing hugin, PTGUI, PTAssembler, autopano or autopano-sift project file.
  • Ctrl-S, save the current project as a hugin pto file.
  • Ctrl-Q, quit hugin.
  • Ctrl-Z, undoes the most recent change to the current project.
  • Ctrl-R, redoes an undo.
  • Ctrl-T, re-optimises the current project. This has exactly the same effect as clicking Optimize Now! in the hugin Optimizer tab.
  • Ctrl-P, shows the hugin Preview window.
  • <F1>, opens the hugin manual.
  • <F3>, shows the hugin Control Points table.
  • <F11>, toggles Full Screen mode.

Additional shortcuts

In addition to this there are a number of keyboard shortcuts available only in the hugin Control Points tab.

Personal tools
Namespaces

Variants
Actions
Navigation
tools
Tools