Hugin Keyboard shortcuts

From PanoTools.org Wiki
(Difference between revisions)
Jump to: navigation, search
m (typos)
m (tidy up)
Line 6: Line 6:
 
* '''Ctrl-Q''', quit hugin.
 
* '''Ctrl-Q''', quit hugin.
 
* '''Ctrl-Z''', undoes the most recent change to the current project.
 
* '''Ctrl-Z''', undoes the most recent change to the current project.
* '''Ctrl-R''', redoes an undo (TODO isn't this usually Ctrl-Y?).
+
* '''Ctrl-R''', redoes an undo.
 
* '''Ctrl-T''', re-optimises the current project.  This has exactly the same effect as clicking '''Optimize Now!''' in the [[hugin Optimizer tab]].
 
* '''Ctrl-T''', re-optimises the current project.  This has exactly the same effect as clicking '''Optimize Now!''' in the [[hugin Optimizer tab]].
 
* '''Ctrl-P''', shows the [[hugin Preview window]].
 
* '''Ctrl-P''', shows the [[hugin Preview window]].

Revision as of 23:55, 13 June 2008

The following keyboard shortcuts are available anywhere in hugin:

  • Ctrl-N, discard the current project and start a new empty project.
  • Ctrl-O, open an existing hugin, PTGUI, PTAssembler, autopano or autopano-sift project file.
  • Ctrl-S, save the current project as a hugin pto file.
  • Ctrl-Q, quit hugin.
  • Ctrl-Z, undoes the most recent change to the current project.
  • Ctrl-R, redoes an undo.
  • Ctrl-T, re-optimises the current project. This has exactly the same effect as clicking Optimize Now! in the hugin Optimizer tab.
  • Ctrl-P, shows the hugin Preview window.
  • <F1>, opens the hugin manual.
  • <F3>, shows the hugin Control Points table.

In addition to this there are a number of keyboard shortcuts available only in the hugin Control Points tab.

Personal tools
Namespaces

Variants
Actions
Navigation
tools
Tools