Hugin Images tab
The Images tab is used to manage the images in a hugin project. Additionally the positions of the images in the final panorama can be edited here.
Images can either be added with the Add individual images... and Add time series of images... button or via drag and drop. Add time series of images... adds all images with a similar file modification time as the selected image; if the the project is empty then a file dialogue opens to allow you to pick this initial file.
Automatic creation of control points can be done by pressing the Create control Points button (if you select just some images, then control points will only be found for those selected). Hugin will then launch whichever control point generator is selected in Settings to add detected control points to the project. The Hugin Preferences determine the list of these autopano programs and can be used and set further options and add new tools to the list.
Remove Points does exactly what its name suggests, it removes control points between the selected images, or all control points if no image is selected.
Often a project has many control points attached to clouds in the sky, this is usually unwanted as clouds move between photos. Clicking Run Celeste will attempt to identify 'sky' control points using the celeste tool and delete them.
Using Clean control points button, hugin will try to find and remove outlying control points using statistical methods.
In the Image Position section, the orientation of the selected images in the final panorama can be specified by yaw, pitch and roll angle (in degrees); and the X, Y, and Z translation parameters. The Reset button will reset all angles and translations to zero. This is useful if the optimizer could not determine the image orientation well and got stuck with a suboptimal result. It is possible to select multiple images at the same time. Changes in orientation will be applied to all selected images.
Note that it is also possible to reset Image Orientation along with other parameters using the Reset... button on the Hugin Camera and Lens tab.
Select Anchor this image for position to indicate that a particular image shouldn't move when optimising with the hugin Optimizer tab. Only one image can be the anchor, and by default this is the first image in the project.
Image orientation can be linked between a group of images if they are already aligned. For example, if they form a bracketed set shot on a sturdy tripod. To do this, select all the images in the stack, and press the New stack button. You can also move images into an existing stack without selecting all the other images in the stack: press Change stack... and enter the stack number you want the selected images to join. The stack number of each image is given in the table.
If your images form approximately aligned stacks, you can create stacks as usual, select all the images and then uncheck Link by the image position. Approximately aligned stacks are common when you shoot bracketed sets handheld, or in windy conditions with a light tripod. Hugin will remember that the images form a stack, but does not force the image orientation and translation to be the same across the stack. This is useful for specifying stacks when you have a Panorama with Stacks control point detector configuration before control point generation. You do not have to manually mark approximately aligned stacks in other circumstances, however.
Selecting Anchor this image for exposure will indicate that a particular image should be used as an unchanging reference anchor when optimising Exposure or White balance in the hugin Exposure tab. Usually this should be the image with the least under or over-exposure or the image with the most typical White balance.